PROCEED AMP2 Especificaciones descargar pdf (Pagina 25)

AMP2-T assembly instructions. © 41Hz Audio / www.41hz.com Revision 1.0T boards

Most Zn-PB solder will melt at around 180ºC. The TP2350B chip is tested for soldering for 10

seconds in 260ºC so you have some margin. Subjecting the chip to high temperatures for a

prolonged time may damage the chip.

The TC2001 chip does not have a heat slug and does not require a heat sink.

APPENDIX 4: Connector pinouts

• Mute jumper; close to awake the amp

• The V5-agnd must be well stabilized / filtered. Voltages above 5.5V will damage the

Tripath chipset

• In1 and In2 should be grounded as indicated, not elsewhere. Input signals above +/- 2.5V

can damage the TC2001 chip.

1 2 ... 20 21 22 23 24 25 26 27

Sin comentarios

PROCEED AMP2 Especificaciones Pagina 25